Micro Reversible Electronic Speed Controller
|
|
|
 |
The Micro Reversible Electronic Speed Controller (ESC) is a small size bidirectional
(reversible) electic motor speed controller. It was designed for small ship models
which needs small power to run and the size available for the ESC is very limited.
It also can be useful for controlling auxilary motors like wench, creane movement,
etc.
more...
|
|
|
MPCC - Model Paint Color Catalog
|
|
|
 |
The R/C Joy is an USB joystick emulation interface for R/C Transmitters. The transmitter
must be connected to the R/C Joy interface using buddy (trainer) connector. The
Interface communicates with the PC via USB interface. The PC recognises it as a
six channel, eight button joystrik. Any program (simulators, games, etc.) which
supports joystick can be controlled by your R/C transmitter.
more...
|
|
|
R/C Joy - R/C Transmitter USB Joystick Interface
|
|
|
 |
The R/C Joy is an USB joystick emulation interface for R/C Transmitters. The transmitter
must be connected to the R/C Joy interface using buddy (trainer) connector. The
Interface communicates with the PC via USB interface. The PC recognises it as a
six channel, eight button joystrik. Any program (simulators, games, etc.) which
supports joystick can be controlled by your R/C transmitter.
more...
|
|
|
PPM R/C Servo Pulse Decoder |
|
|
 |
The Servo Pulse Decoder Card is a decoder for eight channel PPM servo pulse. This
card makes possible to connect your R/C transmitter using its budy (trainer) connector
directly to the decoder card and connect eight servos and/or speed controller without
using R/C receiver, xtals, etc. Beside this the card can be connected to the line
output of your computer's sound card. Using an
apropriate software (see links below)
your computer can generate same signal as your transmitter generates. So without
using any additional hardware (except this card and computer) you can test, adjust
eight servos, speed controllers, etc.
more...
|
|
|
R/C Switch
|
|
|
 |
The R/C Switch converts standard R/C servo pulses into an On/Off signal. Because
the output switch has high current load capability (5Amps) this switch can control
lights, small auxilary motors, solenoids, etc. The hardware is very simple there
is no microcontroller or other programmable device. Only a standard CMOS monostabile
multivibrator and some additional RC elements for timing and signal filtering. No
adjustment or setup is required.
more...
|
|
|
V-Tail Mixer
|
|
|
 |
The V-tail Mixer combines two servo signals and provides two output channels. The
mixer gives you a prefect solution for rudder and elevator control for V-Tailed
airplanes. But beside airplanes it's also can be used for any other vehicle which
has two independent drive system on both side and RPM difference is used (or it
can help) for turning the vehicle. For example a tank with catepillars, ship with
two screws, airplane or hovercraft with to propellers.
more...
|
|
|
